How to install hydraulic plugs

The steps for installing hydraulic plugs are as follows:
Cleaning work: Firstly, it is necessary to clean the installation positions of the hydraulic system and hydraulic plugs to ensure that there is no oil or debris. This can ensure that the hydraulic plug can function properly after installation and has a good sealing effect.
Size confirmation: Check whether the size of the hydraulic plug matches the diameter of the pipeline to ensure they can fully fit.
Surface cleaning: Clean the inner and outer surfaces of pipeline ends and hydraulic plugs to ensure no impurities, rust, etc. This helps to ensure the sealing of the hydraulic plug after installation.
Apply sealant: Apply sealant evenly at the contact area between the hydraulic plug and the pipeline. Sealants can enhance the sealing between hydraulic plugs and pipelines, preventing hydraulic oil leakage.
Insertion installation: Align the hydraulic plug with the pipeline port smoothly, then slowly push it in until it contacts the sealing surface. During the insertion process, ensure that the hydraulic plug is aligned with the pipeline to avoid installation deviation.
Tightening in place: Use a wrench or special tool to tighten the hydraulic plug according to the specified torque, ensuring a firm and reliable connection between it and the pipeline. During the tightening process, be careful not to apply excessive force to avoid damaging the hydraulic plug or pipeline.
After completing the above steps, the installation of the hydraulic plug is completed. Next, you can connect the hydraulic system and test the effectiveness of the hydraulic plug to ensure that it can function properly and achieve the expected sealing effect.
Please note that when installing hydraulic plugs, carefully read the product manual and safety operating procedures, and follow relevant safety regulations for operation.