How To Use Hydraulic Plugs

The basic steps for using hydraulic plugs are as follows:
Cleaning the pipeline: Before using hydraulic plugs, debris, oil stains, etc. inside the pipeline should be cleaned to ensure that the hydraulic plugs can work properly and seal effectively.
Confirm the closed position: Insert the hydraulic plug into the pipeline and confirm its closed position and direction. Ensure that the hydraulic plug can completely seal the pipeline and prevent hydraulic oil leakage.
Install hydraulic plug: Insert the hydraulic plug smoothly into the pipeline and tighten it with a wrench or special tool according to the specified torque. Ensure that the connection between the hydraulic plug and the pipeline is firm and reliable, and that the sealing is good.
In addition, for the installation of the middle plug of the hydraulic chuck, the following steps need to be noted:
Clean installation position: Before installing the middle plug of the hydraulic chuck, ensure that the installation position is free of oil and debris to ensure effective installation.
Install the middle plug: Insert the middle plug into the center hole of the hydraulic chuck and press the chuck tightly through the oil cylinder. Then, tighten the compression nut of the middle plug to ensure that the connection between the chuck and the middle plug is sealed reliably.
Test the effectiveness of use: After installation is completed, the hydraulic system should be connected to test the effectiveness of the hydraulic chuck, ensuring that the hydraulic plug can work properly and achieve the expected sealing effect.
Please note that when using hydraulic plugs, carefully read the product manual and safety operating procedures, and follow relevant safety regulations for operation.